New Arrivals/Restock

5V 12V 24V Photoresistor Relay Module Light Brightness Sensor Timer Detection Controller Switch On/Off with Wires for Car Board(24V)

flash sale iconLimited Time Sale
Until the end
22
25
19

US$20.46 cheaper than the new price!!

Free shipping for purchases over $99 ( Details )
Free cash-on-delivery fees for purchases over $99
Please note that the sales price and tax displayed may differ between online and in-store. Also, the product may be out of stock in-store.
Used  US$13.64
quantity

Product details

Management number 208125510 Release Date 2026/03/22 List Price US$13.64 Model Number 208125510
Category

RelaysProduct Introduction1. Products imported chip control, stable and reliable quality.2. The power section is provided with diode protection, filter capacitor and anti-interference capacitor and 7805 voltage stabilizing chip.3. Providing stable voltage, When the power supply is reversed, the burned out module is avoided.4. The product is equipped with precise adjustable potentiometer, which can adjust sensitivity and delay time better.5. There is power indication and relay pull in indication.6. The module is equipped with high-power relay, which can control the 10A current load.7. Module comes with 50cm long photosensitive resistor sensor.8. The module has time delay and can adjust the delay time to solve the flashing problem of the relay at the critical point of the light.Product ParametersPower supply: DC5V DC12V DC24VStatic current: 12mA 15mA 12mAMaximum power consumption: 72mA 45mA 28mALoad capacity of relay: 250V 10A (AC) 30V 10A (DC)<;80°Delay range: when S2 is plugged in, the delay is 1-20s adjustable; when S2 is not plugged in, the delay is 1-200s adjustableUsage Method1. Product wiring:First connect DC+and DC - to the corresponding DC power supply (for example, connect 5V DC power supply if 5V). If the relay is a power supply that controls 220V AC or is different from the module power supply, please use the first connection method. If the relay is a power supply that controls the same power supply as the module power supply, it can be simpler to use the second connection method;2. Plug in the sensor probe and connect the DC power supply (ensure that the voltage meets the requirements and the polarity cannot be reversed);3. Time delay adjustment method:the time range when jumper S2 is inserted is 1-20s, and 1-200 seconds when jumper S2 is not inserted. The cloc

  • Relays
  • 5V 12V 24V Photoresistor Relay Module Light Brightness Sensor Timer Detection Controller Switch On/Off With Wires for Car Board
Department Unisex Adult
Manufacturer ETURBEV
Item model number ETURBEV
Package Dimensions 1.18 x 0.79 x 0.39 inches; 1.76 ounces

Correction of product information

If you notice any omissions or errors in the product information on this page, please use the correction request form below.

Correction Request Form

Product Review

You must be logged in to post a review